Needle Plate Serger for Pfaff 794 and 796 – Hobbylock (Compatible)

Replacement serger needle plate for Pfaff 794 and 796. The fitment below is taken from the distributor's own listing for this part. Supplied as a compatible aftermarket part — it is not a manufacturer-original part.

This list comes from the distributor's listing for this part. If your model is not named, do not assume it fits — check the part you are removing against the specification below, or ask us with your model number before ordering.

What this part does

The needle plate on an overlocker (serger) carries the stitch finger that the overlock loops form around, as well as the needle hole and feed-dog slots. A damaged stitch finger or a burred needle hole will spoil the stitch.

Specifications

How to tell if this is the right one

Match by the model list. Serger plates vary in needle spacing, stitch finger width and the slot the knife runs in.

Signs you need this part

Burred needle hole, bent or worn stitch finger, loops that no longer form evenly, fabric catching on the plate.

Fitting it

Open the front cover, remove the plate screws, lift out and refit. Hand-turn the handwheel before powering up.

Questions about this part

Does this serger needle plate fit the Pfaff 794?

Yes. The Pfaff 794 is on the distributor's fitment list for this part, along with 796. If your model is not listed on this page, send us the model number and we will check before you order.

Is this the original Pfaff part?

No — it is a compatible aftermarket part made to fit the models listed. It is not a manufacturer-original part.

How long does delivery take?

Orders are dispatched from our distributor's US warehouse. We do not hold stock ourselves and cannot promise same-day dispatch; current delivery estimates are shown at checkout, and we will email you if an item is back-ordered.